Hi Everyone - we are very new to both BODS and Teradata and currently are in a proof-of-concept phase to see how this all works. One of the steps we are stuck on is when you create a BODS program and call the Teradata TPT using a *.bat file, we are unable to see any type of execution results (log file, trace file ,error file, display statements, etc.)
I am assuming we have some type of setup that is incorrect but have not been able to find what or where it needs to be changed. Attached is a screen shot or our BODS program, the corresponding *.bat file and the job log file display in Data Designer.
1) screen shot of a very basic BODS job. All we are doing is executing a *.bat file
2) screen shot of bat file that is being called
3) Data Desidnger log file screen
Does anyone have any suggestions on what we should change in order to have our log and trace files show up? We have been able to view some output files using the TLOGVIEW command but would prefer to see results displayed in the Data Designer. So far, no luck with any or the BODS support documentation - just curious if there is anyone who would know how to resolve this?
Thanks in advance